Suncourt Booster Fans Balance Room Temperature

Suncourt Duct Booster Fan With Flush Fit Design

Suncourt fan flush fit register booster increases airflow to under performing registers improving comfort to rooms that are too hot or too cold.

The Flush Fit Register Booster's quiet 3-speed, dual fans pull extra air out of weak registers, boosting airflow by up to 85%.

• Saves energy and money

• Engineered for maximum airflow

• Fits a 4” x 10” wall/floor register. Adaptor plates are available to fit larger registers (sold separately. See Accessories Tab Above).

• Simply replace existing floor/wall register

• Available in two colors – pearl or brown

• Low voltage – safe for children and pets

• Works automatically with forced air systems

• Push button function controls

• 12 month limited warranty



SUNCOURT REGISTER BOOSTER SETTINGS:

1. Set the Function switch to Auto Heat (winter) or Auto Cool (summer).

2. To adjust the fan motor ON/OFF point rotate the Set Point knob in the proper direction for your heating or cooling application until the fan motor switches ON, then slightly turn the control knob in the opposite direction until the fan motor stops.

DUCT REGISTER BOOSTER FAN INSTALLATION

FLOOR REGISTER 4” X 10”

1. Plug the small molded end of the power cord into the top of the Register Booster. 2. Plug the wall transformer end of the power cord into a 120 Volt AC outlet. 3. Follow directions for operation settings before placing in register. 4. Remove floor register and replace with the Register Booster.

WALL REGISTER 4” X 10”

1. Drill (2) holes with a 3/16” drill bit from the bottom side of the Register Booster grille. The holes should be drilled in the pre-molded location as pictured below. 2. Plug the small molded end of the power cord into the top of the Register Booster. 3. Plug the wall transformer end of the power cord into a 120 Volt AC outlet. 4. Follow directions for operation settings before placing in register. 5. Remove the wall register and replace with the Register Booster. 6. Secure the Register Booster in place.

NEVER EXPOSE YOUR SUNCOURT BOOSTER FANS TO TEMPERATURES OVER 140°F